Buy 🌟 Tribord Race 100, Sailing Yacht Racing Anorak, Men’s 🥰

This anorak is just what you need for training or racing. Its light weight and short cut will make it easier to maneuver on board!

This anorak was designed by our team of yacht racers to protect you from spray and moderate rain for training and inshore racing!

WATERPROOFING

– Coated fabric
– A moderate rain corresponds to a flow of 60 L/m2/h – (= rainfall of 60 mm/h)
– The rainfall simulator reproduces these conditions for 2 hours.
– Component resistant to water pressure of 2,000 mm after aging (= 2,000 Schmerber – average pressure of water during a downpour)

– Water-repellent components (water runs off the fabric).
– 100% taped seams.
– Central opening features a flap with a drainage channel for optimal waterproofing

BREATHABILITY

RET <12: very breathable.

To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapor produced by the body during exercise to escape.

RESISTANCE TO WEAR

– Injected plastic central zipper resistant to salt oxidation.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 1: before washing

Close all zippers and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 2: washing

You can wash your jacket on a synthetic cycle at 86°F or 104°F with your usual detergent. Do not use fabric softener, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Using the right thermal protection based on the water temperature is essential. select a thorough rinse or double rinse to completely remove all detergent residue.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY
step 3: drying

Drying is a crucial phase in reactivating the water-repellent treatment.
We recommend that you lay your jacket flat on a clothes rack and leave it out to dry in the open. Caution: never dry your jacket directly on a radiator.

Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way around.

HOW TO REACTIVATE THE JACKET’S WATER-REPELLENCY

If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you “re-waterproof” it using a spray sold in our stores.

SCORE TO COMPARE THE ENVIRONMENTAL IMPACT OF PRODUCTS

The environmental impact of the product is calculated over its entire lifecycle and with different indicators.
An overall score (ABCDE) is attributed to help you easily identify the products with the best environmental performance by comparing products of the same type with one another (T-shirts, pants, backpacks, etc.).
Decathlon chose to apply this voluntary environmental labeling system.
For more information, visit: http://sustainability.decathlon.com/

Composition

Main fabric : 100.0% Polyamide
Main lining : 100.0% Polyamide
Lining : 100.0% Polyester cationic
Hood : 100.0% Polyamide
Coating : 100.0% Polyurethane

Waterproof : Validated in a simulator reproducing MODERATE RAIN conditions

Breathability : Very breathable coated fabric (RET < 12).

Salt water resistant : Injected plastic zipper.

Pockets : 3 secure pockets. (1 inner and 2 outer).